OngoingSN6507-MINI
PROSN6507-MINI
License
：GPL 3.0
Description
SN6507 Push Pull Transformer Driver for 24V:24V isolated conversion with a TPS7A4701 LDO on the output for tighter regulation at varying load. Design is going to be tested soon when I assemble the boards, transformer used is 1:1.07 ratio, 750319697 by Wurth. Soft start is configured by the capacitor on the SS/ILIM pin and current limit by the resistor, read datasheet for SN6507 for more details. Transformer can be swapped and LDO adjusted to match input and output as long as 0.5A transformer drive current isn't exceeded.
Design Drawing
The preview image was not generated, please save it again in the editor.BOM
Bom empty
CloneProject Members
Intellectual Property Statement & Reproduction Instructions
This is an open-source hardware project. All intellectual property rights belong to the creator. The project is shared on the platform for learning, communication, and research only; any commercial use is prohibited. If your intellectual property rights are infringed on EasyEDA, please notify us by submitting relevant materials in accordance with the Rules for Complaints and Appeals of IPR Infringement.
Users must independently verify the circuit design and suitability when replicating this project. All risks and consequences are borne by the user, and the platform assumes no liability.
Empty
Comment