© 2023 EasyEDA Some rights reserved
1.Easy to use and quick to get started
2.The process supports design scales of 300 devices or 1000 pads
3.Supports simple circuit simulation
4.For students, teachers, creators
1.Brand new interactions and interfaces
2.Smooth support for design sizes of over 30,000 devices or 100,000 pads
3.More rigorous design constraints, more standardized processes
4.For enterprises, more professional users
STD Calibration KerberosSDR
License: GPL 3.0
These switches use PE4259 SPDT High Power UltraCMOS ®10 MHz–3.0 GHz RF Switch. Each switch uses a 3.3V control signal from GPIO LED-s noise source KerberosSDR to select between antenna port 1 or an internal 50 ohm load. This set is intended to be used to automate the Kerberos SDR calibration procedure. It eliminates the need to manually disconnect the antennas for the calibration process.
ID | Name | Designator | Footprint | Quantity | BOM_Supplier | BOM_Supplier Part |
---|---|---|---|---|---|---|
1 | 51 | R2,R3,R4,R5 | R0603 | 4 | LCSC | C81341 |
2 | 10uF | C6 | C0805 | 1 | LCSC | C1713 |
3 | U.FL-R-SMT-1(80) | ANT1,ANT2,ANT3,ANT4,RX4,RX3,RX2,RX1 | RF-SMD_U.FL-R-SMT-1-80 | 8 | LCSC | C88374 |
4 | 600Ω | L1,L2 | L0805 | 2 | LCSC | C21286 |
5 | 1K | R1,R6 | R0603 | 2 | LCSC | C25585 |
6 | PE4259-63 | U1,U2,U3,U4 | SC-70-6_L2.2-W1.3-P0.65-LS2.1-BL | 4 | LCSC | C470892 |
7 | HDR-M-2.54_1x1 | 3.3V,CTL,GND_CTL,GND_VCC,SW_1,SW_2 | RECTANGLE | 6 | LCSC | C81276 |
8 | 100nF | C14,C5,C1,C2,C3,C4,C7,C8,C9,C10,C11,C12 | C0402 | 12 | LCSC | C60474 |
9 | BZV55C3V6_C545373 | D1 | SOD-80_L3.5-W1.5-RD | 1 | LCSC | C545373 |
Unfold
Loading...
Do you need to add this project to the album?