OngoingMobiflight panel template
STDMobiflight panel template
License
：CC-BY-NC-SA 3.0
Description
Just a simple schema as a starting point that has the good foodprint for the Mega Mini already placed.
There are many footprints for this "small footprint" Arduino Mega, this one seems to have the pins numbered sequentially on each side, making it easier to wire encoders etc in consecutive pins.
The pushbuttons are Multimec 3FTH9, but you can naturally change the footprint to something else. These are just ones I have used before.
The encoder is EC11EBB24C03 that you can find on aliexpress (probably a knockoff clone) or from digikey etc.
Disclaimer: I have not yet tested the panel I made with this method, will update the project in a few days once I get my "mini" arduino mega and see if my idea actually works.
Design Drawing
The preview image was not generated, please save it again in the editor.BOM
Bom empty
CloneProject Members
Intellectual Property Statement & Reproduction Instructions
This is an open-source hardware project. All intellectual property rights belong to the creator. The project is shared on the platform for learning, communication, and research only; any commercial use is prohibited. If your intellectual property rights are infringed on EasyEDA, please notify us by submitting relevant materials in accordance with the Rules for Complaints and Appeals of IPR Infringement.
Users must independently verify the circuit design and suitability when replicating this project. All risks and consequences are borne by the user, and the platform assumes no liability.
Empty
Comment