OngoingSmokeV1
PROSmokeV1
License
：Public Domain
Description
PCB for smoke simulator. You need optotransistor, diode and 3 10440 li-ion batteries.
M2 nut 2 pcs and 2 M2x10 brass sets for solder wires.
H1 - battery connector
H2 - coil connector
H3 - power on/off switch
H4 - button for check batter charge
H5 - LED connector (second must be connected to ground)
H6 - photodiode connector (second must be connected to ground)
Parts:
-SPL-10 coil: 1
-M4x12: 1
-M3x12: 2
-10440 li-ion: 3
-M2 nut: 2
-M2x10: 2
Design Drawing
The preview image was not generated, please save it again in the editor.BOM
Bom empty
CloneProject Members
Intellectual Property Statement & Reproduction Instructions
This is an open-source hardware project. All intellectual property rights belong to the creator. The project is shared on the platform for learning, communication, and research only; any commercial use is prohibited. If your intellectual property rights are infringed on EasyEDA, please notify us by submitting relevant materials in accordance with the Rules for Complaints and Appeals of IPR Infringement.
Users must independently verify the circuit design and suitability when replicating this project. All risks and consequences are borne by the user, and the platform assumes no liability.
Empty
Comment