OngoingiDryer r2.1 / filament dryer
STDiDryer r2.1 / filament dryer
License
：GPL 3.0
Description
iDryer 2.1
Upgraded and reduced filament dryer controller PCB. The PCB is designed for use with the new firmware.
The iDryer is already proven and recognized by the https://t.me/iDryer community.
The iDryer heats up to 100 degrees Celsius, has a wide range of functionality, is equipped with scales and filament end signal output. Suitable for printing with nylon (PA 6, PA 12...) and other engineering plastics and composites based on them.
The project contains all necessary files and firmware, full documentation of the project https://docs.idryer.org/.
Project video https://www.youtube.com/@iDryerProject
https://github.com/pavluchenkor/iDryerController
Design Drawing
The preview image was not generated, please save it again in the editor.BOM
Bom empty
Clone
Intellectual Property Statement & Reproduction Instructions
This is an open-source hardware project. All intellectual property rights belong to the creator. The project is shared on the platform for learning, communication, and research only; any commercial use is prohibited. If your intellectual property rights are infringed on EasyEDA, please notify us by submitting relevant materials in accordance with the Rules for Complaints and Appeals of IPR Infringement.
Users must independently verify the circuit design and suitability when replicating this project. All risks and consequences are borne by the user, and the platform assumes no liability.
Empty
Comment