OngoingiDryer r2 / filament dryer
STDiDryer r2 / filament dryer
License
：GPL 3.0
Description
Power supply voltage is 220 volts and 24 volts (see diagram)
It is possible to use heating elements from the table or hitblock of 3D printer or any other alternative heating elements with voltage of 220 or 24V.
The project was initially realized without temperature control using self-regulating heating cable https://github.com/pavluchenkor/iDryer and later finalized to the version with temperature control.
https://docs.idryer.org/
https://github.com/pavluchenkor/iDryerController
Design Drawing
The preview image was not generated, please save it again in the editor.BOM
Bom empty
CloneProject Members
Intellectual Property Statement & Reproduction Instructions
This is an open-source hardware project. All intellectual property rights belong to the creator. The project is shared on the platform for learning, communication, and research only; any commercial use is prohibited. If your intellectual property rights are infringed on EasyEDA, please notify us by submitting relevant materials in accordance with the Rules for Complaints and Appeals of IPR Infringement.
Users must independently verify the circuit design and suitability when replicating this project. All risks and consequences are borne by the user, and the platform assumes no liability.
Empty
Comment