OngoingHLK LD2410 Power and Extension Board
STDHLK LD2410 Power and Extension Board
License
：Public Domain
Description
Note: Please bare with me, this is my first PCB design!
The intention of this PCB is to attach an HLK2410 millimeter wave 24 GHZ radar module presence sensor to a USB type C power with as little extra space as possible.
While doing so, I realised that there is enough space below the HiLink Module to also add a 3.3V voltage regulator, so a microcontroller and other sensors can be powered directly from the same USB connection.
I also often read that people are frustrated with the small 1.27mm pins, so I added normal 2.54mm pin holes to the PCB, so you can attach it easily to any default breakout board and can more easily solder your wires or whatever to the relevant pins.
Design Drawing
The preview image was not generated, please save it again in the editor.BOM
Bom empty
CloneProject Members
Intellectual Property Statement & Reproduction Instructions
This is an open-source hardware project. All intellectual property rights belong to the creator. The project is shared on the platform for learning, communication, and research only; any commercial use is prohibited. If your intellectual property rights are infringed on EasyEDA, please notify us by submitting relevant materials in accordance with the Rules for Complaints and Appeals of IPR Infringement.
Users must independently verify the circuit design and suitability when replicating this project. All risks and consequences are borne by the user, and the platform assumes no liability.
Empty
Comment