CompletedNFC Badge/Keychain (Kazuma Konosuba)
PRONFC Badge/Keychain (Kazuma Konosuba)
License
：GPL 3.0
Description
Project for the Celebrate Childhood with a Colorful PCB event
Small NFC badge featuring Kazuma, the main character of the anime KONOSUBA!
There's a small loop at the top of the board so it can be used as a slightly oversize keychain
On the back side of the board there's a NT3H2211 IC with just a couple of required passive components, the NFC antenna is also on the bottom layer.
R1 is a 0 ohm resistor or solder blob to bridge VCC and VOUT, C2 and C3 are spaces for tuning capacitors, they are not strictly required and can be left unpopulated if you don't want to fine-tune the antenna.
Finally there are some pads where it's possible to solder a 2.54mm header and talk to the chip directly via its I2C interface, useful for some extra thinkering/debugging.
Design Drawing
The preview image was not generated, please save it again in the editor.BOM
Bom empty
CloneProject Members
Intellectual Property Statement & Reproduction Instructions
This is an open-source hardware project. All intellectual property rights belong to the creator. The project is shared on the platform for learning, communication, and research only; any commercial use is prohibited. If your intellectual property rights are infringed on EasyEDA, please notify us by submitting relevant materials in accordance with the Rules for Complaints and Appeals of IPR Infringement.
Users must independently verify the circuit design and suitability when replicating this project. All risks and consequences are borne by the user, and the platform assumes no liability.
Empty
Comment