check in
Ongoing

LCD 8 Bit Ribbon Cable Adaptor

STDLCD 8 Bit Ribbon Cable Adaptor

tag

820
0
0
0
Mode:Full

License

Creation time:2021-07-12 14:29:28Update time:2021-08-19 15:10:16

Description

Small board to convert from 2.54mm or 1.27mm pitch on LCD character displays to a flat ribbon cable.

Both patterns are on one board. Just cut the board in half to seperate them. V-scoring would be great. I had them made at a manufacturer here in the US due to timing constraints. They were made "bare bones", with no solder mask or silk screen.

Pay close attention to where Pin 1 is. Moving the IDC header to the back of the board will change the position of Pin 1.

Don't use the BOM listed at the bottom - the 1.27mm header is wrong. Find equilivents of the part numbers listed on the schematic.

 

Separated with IDC Connector

 

  Separated, with IDC connector installed.

 

 

90 Degree

 

2.54mm Pitch with 90 degree header.

 

 

180 Degree

 

2.54mm Pitch 180 degree header.

 

 

1.27mm Pitch

 

1.27mm Pitch installed on back of 2x12 LCD Display. The display has 15 pins,

so I snipped the last pin off of the header.

 

 

1.27mm Pitch Side

 

1.27mm Pitch, side view.

 

 

 

 

 

Design Drawing

The preview image was not generated, please save it again in the editor.

BOM

Bom empty

Attachments

OrderFile nameDownload times
No data
Clone
Add to Album
0
0
Share
Report

Project Members

Comment

All Comments(1)
Sort by time|Sort by popularity
Followers0|Likes0
Related projects
Empty

Bottom Navigation