© 2022 EasyEDA Some rights reserved
1.Easy to use and quick to get started
2.The process supports design scales of 300 devices or 1000 pads
3.Supports simple circuit simulation
4.For students, teachers, creators
1.Brand new interactions and interfaces
2.Smooth support for design sizes of over 30,000 devices or 100,000 pads
3.More rigorous design constraints, more standardized processes
4.For enterprises, more professional users
Std EditionEsp8266 3 relay touch sensor v2
License: Public Domain
The smart relay touch V2 Runs with Wemos D1 Mini with 3 relay and 3 touch sensorThe relay input 3A v220-AC max
Tasmota Link Tasmota
Configure Tasmota for Wemos Generic Module In the Configuration -> Configure Module page, select Module Type: "18 Generic" (releases before 5.12.0 this was called "Wemos D1 Mini"). After Saving the settings, the WEMOS reboots with the Generic configuration. The first time you switch to "18 Generic" you will NOT see all the options as seen in the picture below YET. You have to save "18 Generic" first and when you go there again after the reboot you get the long table where you can change all the pin's parameters. These steps are confirmed to also work with the Wemos D1 mini PRO v2.0.0.
esp8266 relay Schematics
Open in editorsmart relay esp8266 PCB
Open in editorTouch Sensor Schematics
Open in editorTouch Sensor PCB
Open in editor