CompletedCH335 HUB
PROCH335 HUB
License
：GPL 3.0
Description
The controller chip is CH335F. Power of each port is controlled by CH217K. You may use uhubctl to control power of each port. So the power of each USB peripheral can be controlled by software.
R16 set the hub to work as Bus-powered. R15 set the hub to work as individual port control.
Note the hub will report as a 200mA device in bus-powered mode. So if the devices attached to hub require more than that, computer may refuse to initiate device. A EEPROM can be used to replace the 2 resistors to set all parameters in descriptor.
Here is also a 3D printed case for the board. The screw holes are designed to fit M3 counter-sunk machine screw. Depending on your machine accuracy, you may need to enlarge the hole with 2.5mm drill bit and tap M3 thread inside. Also the counter-sunk hole may need to be enlarged.
Design Drawing
The preview image was not generated, please save it again in the editor.BOM
Bom empty
CloneProject Members
Intellectual Property Statement & Reproduction Instructions
This is an open-source hardware project. All intellectual property rights belong to the creator. The project is shared on the platform for learning, communication, and research only; any commercial use is prohibited. If your intellectual property rights are infringed on EasyEDA, please notify us by submitting relevant materials in accordance with the Rules for Complaints and Appeals of IPR Infringement.
Users must independently verify the circuit design and suitability when replicating this project. All risks and consequences are borne by the user, and the platform assumes no liability.
Empty
Comment