OngoingAtmega328pb to Uno
STDAtmega328pb to Uno
License
：CERN Open Hardware License
Description
Atmega328pb Adapter
This project is an adapter to put at atmega328pb on an Arduino Uno board. No modifications are needed for the Uno board. Remove the socketed Atmega328 P and this Atmega 328PB adapter will pop right in. This project was sponsored by JLCPCB. I recommend JLC PCB. $2 For Your PCB+PCBA, Register to Get $54 Coupons: https://jlcpcb.com/IYB
MiniCore
You will need to add minicore to the Arduino IDE. Search GitHub for minicore to get more details on this step.
Assembly
Due to the crystal oscillator used, you will need either a hot plate or a hot air station to assemble this. The 0402 caps might be difficult for some to hand solder.
BOM
2 0402 12pF Cap
2 0603 0.1UF Cap
1 Atemga328pb
1 TSX-3225 16.0000MF18X-AC3
1 40pin 2.54mm strip header (this will be trimmed down)
Design Drawing
The preview image was not generated, please save it again in the editor.BOM
Bom empty
CloneProject Members
Intellectual Property Statement & Reproduction Instructions
This is an open-source hardware project. All intellectual property rights belong to the creator. The project is shared on the platform for learning, communication, and research only; any commercial use is prohibited. If your intellectual property rights are infringed on EasyEDA, please notify us by submitting relevant materials in accordance with the Rules for Complaints and Appeals of IPR Infringement.
Users must independently verify the circuit design and suitability when replicating this project. All risks and consequences are borne by the user, and the platform assumes no liability.
Empty
Comment