AV Famicom Buddy

1 month ago

Profile:# FT-AV-Fami-Buddy This board is currently untested. Feel free make one and leave feedback! A breakout board for NESRGB installs on AV Famicoms. Attaches to the underside of the AV multiout and extends pads to the side of the board. This allows installers to run ribbon or wire straight to pads rather than trying to solder directly to the pins.

Open source license:

  • 88
  • 0
  • 0

Description

# FT-AV-Fami-Buddy
This board is currently untested. Feel free make one and leave feedback!

A breakout board for NESRGB installs on AV Famicoms. Attaches to the underside of the AV multiout and extends pads to the side of the board. This allows installers to run ribbon or wire straight to pads rather than trying to solder directly to the pins.

 

# PCB Manufacturing
Thickness: 0.8

 

# Installation
This board is deisgned to be installed alongside an NESRGB mod. 

If you are concerned about the potential "jailbars" which may be present after the NESRGB installtion, please reference this guide to fix the noisy ground of the AV multiout. If "jailbars" do not conern you, then continue. https://www.laserbear.net/blogs/news/removing-jailbars-from-av-famicom-nesrgb

After the NESRGB is install and you're running wire to multiout, solder this board to the underside of the AV multiout so that the screw hole is aligned properly with the mainboard. Solder into place and then run wires accordingly to the pads. CS# runs to the SYNC pin of AV multiout for this board.

Documents

AV Famicom Buddy Board v1.0

Open in editor

BOM

Empty

Project Members

服务时间

周一至周五 9:00~18:00
  • 0755 - 2382 4495
  • 153 6159 2675

服务时间

周一至周五 9:00~18:00
  • 立创EDA微信号

    easyeda

  • QQ交流群

    664186054

  • 立创EDA公众号

    lceda-cn