CompletedSpookyDuino Uno (Halloween)
License
：GPL 3.0
Description
SpookyDuino UNO
My entry for the 2025 Halloween contest
I designed this clone of the Arduino Uno board trying to keep it as simple as possible while not removing useful features. Unlike a lot of other clone boards this still uses a socketed Atmega328 chip, which is easier to remove and replace if necessary.
Features:
- USB type A socket for power and to upload sketches
- CH340C USB to serial converter
- ICSP header
- RX/TX leds + an extra LED on pin 13 like the original Arduino board
- Barrel jack for up to 12V input power
- Reset button
And of course it features colorful silkscreen with a Halloween theme!
Schematic and PCB design by me. Silkscreen art by Fildzahnandya
Design Drawing
The preview image was not generated, please save it again in the editor.BOM
Bom empty
CloneProject Members
Intellectual Property Statement & Reproduction Instructions
This is an open-source hardware project. All intellectual property rights belong to the creator. The project is shared on the platform for learning, communication, and research only; any commercial use is prohibited. If your intellectual property rights are infringed on EasyEDA, please notify us by submitting relevant materials in accordance with the Rules for Complaints and Appeals of IPR Infringement.
Users must independently verify the circuit design and suitability when replicating this project. All risks and consequences are borne by the user, and the platform assumes no liability.
Empty
Comment