CompletedST7796S Triple Adapter
STDST7796S Triple Adapter
License
：GPL 3.0
Description
For use with the ST7796S 3.5" TFT SPI Touchscreen Display
Raspberry Pi Pico, Adafruit Feather, Adafruit QT Py/Seed Xiao Triple form factor display adapter board. You can mix and match 1 MCU with add-on boards from different form factors.
- SPI TFT Touch Display & SDCard confirmed working
- Stemma QT port (unassembled)
- 5V Neopixel breakouts with pins D11 & D12 close by.
- 6mm tactile reset button
- Interrupt pin not connected but a pad is available for use
- Footprint for use with: Adafruit Feather, Adafruit QT Py or Seed Xiao, Raspberry Pi Pico
- Intended for use with 1 MCU & 2 add-on board configuration
- All footprints have specific shared SPI & I2C pins + Stemma QT I2C.
One global reset button works for any combination of boards. StemmaQT plug on the bottom.
Adapter intended to plug into the back of the ST7796S display for use with microcontrollers.
Design Drawing
The preview image was not generated, please save it again in the editor.BOM
Bom empty
CloneProject Members
Intellectual Property Statement & Reproduction Instructions
This is an open-source hardware project. All intellectual property rights belong to the creator. The project is shared on the platform for learning, communication, and research only; any commercial use is prohibited. If your intellectual property rights are infringed on EasyEDA, please notify us by submitting relevant materials in accordance with the Rules for Complaints and Appeals of IPR Infringement.
Users must independently verify the circuit design and suitability when replicating this project. All risks and consequences are borne by the user, and the platform assumes no liability.
Empty
Comment