© 2024 EasyEDA Some rights reserved ISO/IEC
Brand new interactions and interfaces
Smooth support for design sizes of over 3W
devices or 10W pads
More rigorous design constraints, more
standardized processes
For enterprises, more professional users
Easy to use and quick to get started
The process supports design scales of 300
devices or 1000 pads
Supports simple circuit simulation
For students, teachers, creators
STD universal power supply for audio amplifier
Mode:
I designed this power supply based on the universal power supply from diyaudio store, using components that are readily available in Southeast Asia, where I am from. The bleeder resistors, R1 and R9, have values ranging from 4.7k to 22k, depending on the desired voltage output and the capacitance of the capacitors used. The higher the voltage output and capacity of the capacitors, the larger value resistors are required. R2 to R6 and R10 to R14 are Pi resistors with a value of 0.47 to 1 ohm. R7 and R15 are LED drop resistors with a value of around 4.7k to 10k. R8 and R16 are output resistors with a value of 1 ohm. For the snubber caps, I used Elna LAO series 10,000 microfarad 80V. Please refer to the datasheet for space requirements if you are not using the same capacitors. The bridge rectifier used is GBPC3510W, chosen for its easy availability as a second-hand component and its affordable price of less than 1 USD (original Vishay!) at least in Indonesia.
pcb universal power supply for audio amplifier
Open in Editorpcb universal power supply for audio amplifier
Open in Editorpcb universal power supply for audio amplifier
Open in EditorLoading...
Do you need to add this project to the album?