OngoingPi Pico RP2040 custom clone v1.0
STDPi Pico RP2040 custom clone v1.0
License
：GPL 3.0
Description
All GPIO pins are exposed.
Pin layout mostly follows that of the pi pico. Left header pins are pin to pin compatible and right header pins share the same layout up to GPIO22.
VBUS and GND pins are also pin compatible.
I refered to the Pi Pico documentation and RP2040 Documentation for design.
Pi Pico Documentation: https://datasheets.raspberrypi.com/pico/pico-datasheet.pdf
RP2040 Documentation: https://datasheets.raspberrypi.com/rp2040/rp2040-datasheet.pdf
TYPE C port
1117 3.3 LDO
16MB flash
12MHz Crystal
Plans to add a batt terminal, oled, opamps, and instrumentation amp in future versions.
Design Drawing
The preview image was not generated, please save it again in the editor.BOM
Bom empty
CloneProject Members
Intellectual Property Statement & Reproduction Instructions
This is an open-source hardware project. All intellectual property rights belong to the creator. The project is shared on the platform for learning, communication, and research only; any commercial use is prohibited. If your intellectual property rights are infringed on EasyEDA, please notify us by submitting relevant materials in accordance with the Rules for Complaints and Appeals of IPR Infringement.
Users must independently verify the circuit design and suitability when replicating this project. All risks and consequences are borne by the user, and the platform assumes no liability.
Empty
Comment