CompletedIntellivision Secam P2 - RGB out
STDIntellivision Secam P2 - RGB out
License
：CERN Open Hardware License
Description
This project allows to connect an Intellivision to a modern disply device using RGB (SCART) signals.
This module works for "SECAM P2" or and most PAL versions of the console having an LM1886N on board.
This module also ca, also be used in VideoPAC and Atari VCS SECAM consoles with same RGB (SCART) output.
The schematic is mainly three 3bits DACs for Red, Green and Blue signals.
The SYNC signal is buffered and can be inverted or not (invertion is required for VideoPAC console).
Audio signal is justed passed through a capacitor to remove potential DC offset.
The attached document provides instatlation details in all 3 consoles and provide also require SCART cable cabling.
Design Drawing
The preview image was not generated, please save it again in the editor.BOM
Bom empty
CloneProject Members
Intellectual Property Statement & Reproduction Instructions
This is an open-source hardware project. All intellectual property rights belong to the creator. The project is shared on the platform for learning, communication, and research only; any commercial use is prohibited. If your intellectual property rights are infringed on EasyEDA, please notify us by submitting relevant materials in accordance with the Rules for Complaints and Appeals of IPR Infringement.
Users must independently verify the circuit design and suitability when replicating this project. All risks and consequences are borne by the user, and the platform assumes no liability.
Empty
Comment