OngoingSuperSimpleMultiSwitch
PROSuperSimpleMultiSwitch
License
：CC BY-NC-SA 4.0
Description
This module realizes a so-called "MultiSwitch": it can switch on/off up to 16 consumer e.g. LEDs, brushed DC-motors, ...
This module is controlled via a RC-transmitter/receiver. The module is connected to the receiver via a (bidirectional) serial CRSF connection. Typically the transmitter runs EdgeTx and the transmitters RF-module runs ExpressLRS, so the receiver also runs ExpressLRS. But in other usage scenarios also TBS Crossfire maybe used.
On the handset/transmitter a LUA-widget with touch-buttons, momentary-buttons, check-boxes is normally used as an UI to this module.
The exist other - more sophisticated - "MultiSwitch" modules (e.g. using STM32 µC). But this one is simple (AVR-DA µC) and eays to reproduce. If one likes the module can be built without this PCB but using a breadboard or similar.
Design Drawing
The preview image was not generated, please save it again in the editor.BOM
Bom empty
CloneProject Members
Intellectual Property Statement & Reproduction Instructions
This is an open-source hardware project. All intellectual property rights belong to the creator. The project is shared on the platform for learning, communication, and research only; any commercial use is prohibited. If your intellectual property rights are infringed on EasyEDA, please notify us by submitting relevant materials in accordance with the Rules for Complaints and Appeals of IPR Infringement.
Users must independently verify the circuit design and suitability when replicating this project. All risks and consequences are borne by the user, and the platform assumes no liability.
Empty
Comment