CompletedMeshtastic Heltec CT62 tiny board
STDMeshtastic Heltec CT62 tiny board
License
：GPL 3.0
Description
DIY PBC for Meshtactic messenger, based on Heltec CT62 Lora module.
Tiny (near 3x4cm), only few smd for minimal setup.
Allows add I2c display/sensors and LiPo charging circuit.
Unfortunally, MCU (esp32c3) is not very energy effective, so battery life not too long (heltec board consumes near 0.5w)
Github link for project: https://github.com/mrekin/MeshtasticCustomBoards/tree/main/firmware/variants/diy/diy-heltec-ct62-tiny-1.02
FW variant is working minimum, need to check it for completeness.
Used custom fw variant, but possible official variant for ct62 can be used, need to check.
Many thanks Meshtastic team for great project!
Design Drawing
The preview image was not generated, please save it again in the editor.BOM
Bom empty
CloneProject Members
Intellectual Property Statement & Reproduction Instructions
This is an open-source hardware project. All intellectual property rights belong to the creator. The project is shared on the platform for learning, communication, and research only; any commercial use is prohibited. If your intellectual property rights are infringed on EasyEDA, please notify us by submitting relevant materials in accordance with the Rules for Complaints and Appeals of IPR Infringement.
Users must independently verify the circuit design and suitability when replicating this project. All risks and consequences are borne by the user, and the platform assumes no liability.
Empty
Comment