Description

1.Design requirements

• Many sizes of SMD components (capacitors and resistors) are available as through-hole Pitch 2.54mm, 5,08mm, 7.62mm, 10.16mm components.
• Even parts that have been discontinued can be repaired using this conversion board and SMD parts.
• It is not suitable for use in circuits where noise problems are likely to occur.
  You cannot use a current that exceeds the performance of SMD parts, so please use appropriate parts.
• The signal is separated from the center.
• There is no BOM, and by replacing the pin header with a single wire, it loses strength but can accommodate various pitches and holes.
• The lost strength needs to be reinforced with hot bond, etc.

2.Overall design program

Available in various sizes and connected to pin headers. That's all.

When using it, it is practical to change the pin header to a straight type and output it in a panelized manner.