OngoingESP8266 ESPHome
STDESP8266 ESPHome
1.9k
0
0
2
Mode:Full
License
：GPL 3.0
Creation time:2021-01-31 09:14:51Update time:2022-09-11 16:15:04
Description
ESP Wifi
This board uses power from USB
- Must be programmed though USB
- this board have a programmed switch the holds the GPIO0 to ground during power up to go into program mode
- If programmed in ESPHome for Home Assistant use ESP8266 ESP-01
- Can use any flash campatible with ESP8266
- All IO and ADC in are connected to two headers for expansion board
- Can be used for any ESP8266 application
- Sensors
- Relays
- Wireless communication
- Webserver
- Motor controll
Design Drawing
The preview image was not generated, please save it again in the editor.BOM
Bom empty
CloneAdd to Album
0
0
Share
Report
Project Members
Intellectual Property Statement & Reproduction Instructions
This is an open-source hardware project. All intellectual property rights belong to the creator. The project is shared on the platform for learning, communication, and research only; any commercial use is prohibited. If your intellectual property rights are infringed on EasyEDA, please notify us by submitting relevant materials in accordance with the Rules for Complaints and Appeals of IPR Infringement.
Users must independently verify the circuit design and suitability when replicating this project. All risks and consequences are borne by the user, and the platform assumes no liability.
Followers0|Likes0
Related projects
Empty
Comment