OngoingNE5534 microphone preamp
STDNE5534 microphone preamp
License
：GPL 3.0
Description
For more information about the project visit this Instructables page:
NE5534 Amplifier and vibration reducer
- Battery input is 4.2V MAX (single cell LiPo / LiIon)
- Power input is 6-10V from a DC-DC boost converter
- Use shielded cables for Mic in and Line out, preferably a ground plane on both sides of the PCB
- You may want to use a smaller cap than 1000uF for C4, put it on (thick) wires outside of the PCB or lay it horizontally
- You may want to use an LDO between the boost converter and power input to get rid ofnoise and ripple, ideally one with high PSR (like LM317)
- 220k potentiometer is optional (if unused, replace with a wire / 0ohm resistor)
Dont forget the ground plane !! Dont forget to connect all islands of the ground pane !!
Design Drawing
The preview image was not generated, please save it again in the editor.BOM
Bom empty
CloneProject Members
Intellectual Property Statement & Reproduction Instructions
This is an open-source hardware project. All intellectual property rights belong to the creator. The project is shared on the platform for learning, communication, and research only; any commercial use is prohibited. If your intellectual property rights are infringed on EasyEDA, please notify us by submitting relevant materials in accordance with the Rules for Complaints and Appeals of IPR Infringement.
Users must independently verify the circuit design and suitability when replicating this project. All risks and consequences are borne by the user, and the platform assumes no liability.
Empty
Comment