OngoingPro Micro Breakout (Arcade)
STDPro Micro Breakout (Arcade)
License
：MIT
Description
A generic Arduino Pro Micro breakout board for projects such as an arcade joystick controller based on the open source DaemonBite Arcade software (https://github.com/MickGyver/DaemonBite-Arcade-Encoder). Pins for the arcade buttons and stick are labelled on the front of the board. Generic pin names labelled on the back of the board.
Only the arcade buttons that are used are broken out. D5/D7 are broken out to a header below the Pro Micro along with the VCC, GND, and RAW pins for convenience. There is also a 6mm tack switch option to make it easier to double tap reset when programming the Pro Micro device.
Design Drawing
The preview image was not generated, please save it again in the editor.BOM
Bom empty
CloneProject Members
Intellectual Property Statement & Reproduction Instructions
This is an open-source hardware project. All intellectual property rights belong to the creator. The project is shared on the platform for learning, communication, and research only; any commercial use is prohibited. If your intellectual property rights are infringed on EasyEDA, please notify us by submitting relevant materials in accordance with the Rules for Complaints and Appeals of IPR Infringement.
Users must independently verify the circuit design and suitability when replicating this project. All risks and consequences are borne by the user, and the platform assumes no liability.
Empty
Comment