OngoingDcStick
STDDcStick
License
：CC-BY-NC-SA 3.0
Description
This is a TI DRV8874 DC motor driver for use Phase/Enable signaling. It also supports the ENable signal (enabled logic HIGH) and Fault signals (on the M2 pin (used as an SPI CS signal on other drivers.)
This should handle motors up to 24VDC and 2A.
Design Drawing
The preview image was not generated, please save it again in the editor.BOM
Bom empty
CloneProject Members
Intellectual Property Statement & Reproduction Instructions
This is an open-source hardware project. All intellectual property rights belong to the creator. The project is shared on the platform for learning, communication, and research only; any commercial use is prohibited. If your intellectual property rights are infringed on EasyEDA, please notify us by submitting relevant materials in accordance with the Rules for Complaints and Appeals of IPR Infringement.
Users must independently verify the circuit design and suitability when replicating this project. All risks and consequences are borne by the user, and the platform assumes no liability.
Empty
Comment