OngoingDIY Oscilloscope
STDDIY Oscilloscope
License
：MIT License
Description
This is a PCB design of the GitHub project https://github.com/BojanJurca/Esp32_oscilloscope. It interfaces with a ESP32-S2-DevKitM-1 and gives pinouts for unused pins. It used two pins, pin 3 and ground, these pins are the ones used for the oscilloscope. All you'd need to do to get it running is to put the batteries in and follow the steps given in the github link above. The board has two outputs for wires to plug into.
Design Drawing
The preview image was not generated, please save it again in the editor.BOM
Bom empty
CloneProject Members
Intellectual Property Statement & Reproduction Instructions
This is an open-source hardware project. All intellectual property rights belong to the creator. The project is shared on the platform for learning, communication, and research only; any commercial use is prohibited. If your intellectual property rights are infringed on EasyEDA, please notify us by submitting relevant materials in accordance with the Rules for Complaints and Appeals of IPR Infringement.
Users must independently verify the circuit design and suitability when replicating this project. All risks and consequences are borne by the user, and the platform assumes no liability.
Empty
Comment