OngoingRP2040_USBC
STDRP2040_USBC
License
：Public Domain
Description
Minimalistic rp2040 USB-C board, with:
- Single-side PCB (except the USB-C connector that is soldered on both sides) - 1mm PCB needed for the connector
- a push button on GPIO 15
- a red Led on GPIO 12, emitting on the side
- a 2MB flash memory
- a "boot" button to enter to the bootloader
Design Drawing
The preview image was not generated, please save it again in the editor.BOM
Bom empty
CloneProject Members
Intellectual Property Statement & Reproduction Instructions
This is an open-source hardware project. All intellectual property rights belong to the creator. The project is shared on the platform for learning, communication, and research only; any commercial use is prohibited. If your intellectual property rights are infringed on EasyEDA, please notify us by submitting relevant materials in accordance with the Rules for Complaints and Appeals of IPR Infringement.
Users must independently verify the circuit design and suitability when replicating this project. All risks and consequences are borne by the user, and the platform assumes no liability.
Empty
Comment