OngoingBreadboard Buddies - IN/OUT
STDBreadboard Buddies - IN/OUT
License
：Public Domain
Description
Breadboard Buddies - IN/OUT provdes three 3.5mm mono jacks to source and send signals from the breadboard.
- One buffered input with AC decoupling cap (RC filter with 1uF and 200k resistor)
- One DC coupled unbuffered input, labelled CV
- One DC coupled bufferd output with a 1k resistor
NOTE:
The board needs power for the op amp on the following pins
- VCC (+12V)
- VEE (-12V)
- GND (0V/Ground)
The buffer is provided by an onboard voltage following op amp (LM358).
Design Drawing
The preview image was not generated, please save it again in the editor.BOM
Bom empty
CloneProject Members
Intellectual Property Statement & Reproduction Instructions
This is an open-source hardware project. All intellectual property rights belong to the creator. The project is shared on the platform for learning, communication, and research only; any commercial use is prohibited. If your intellectual property rights are infringed on EasyEDA, please notify us by submitting relevant materials in accordance with the Rules for Complaints and Appeals of IPR Infringement.
Users must independently verify the circuit design and suitability when replicating this project. All risks and consequences are borne by the user, and the platform assumes no liability.
Empty
Comment