CompletedLHS PI Bed Heater - 200x200mm
PROLHS PI Bed Heater - 200x200mm
License
：CC BY-NC-SA 3.0
Description
For the LH Stinger 3D Printer
LH Stinger PI Bed Heater - 200x200mm - 24V DC 200W
https://github.com/lhndo/LH-Stinger/tree/main/PCB/PI%20Bed%20Heater%20-%20200mm
Installation Video:
https://www.youtube.com/watch?v=Hy14AWyfAY4
BOM
PCB
- Flex Polyimide Base
- Copper Thickness: 1oz (35 µm)
- Backside Adhesive 3M90777
- Silkscreen: White
- Weight: 19g
Power
- Voltage: 24V DC
- Resistance: 2.66 Ohm @ 25C (Please see the included Excel screenshot for calculations)
- Power: 216W @ 25C (+-10%)
BOM
Thermistor
- NTC 100K 3950
Power Cable
- 16 AWG Multi-strand Soft Electrical Silicone Cable
- XT60 female connector
- Length: 90cm
Thermistor Cable
- PTFE/FEP Wire around 24-26 AWG
- 2 pin JST XH 2.54 female connector
- Length: 90cm
Design Drawing
The preview image was not generated, please save it again in the editor.BOM
Bom empty
CloneProject Members
Intellectual Property Statement & Reproduction Instructions
This is an open-source hardware project. All intellectual property rights belong to the creator. The project is shared on the platform for learning, communication, and research only; any commercial use is prohibited. If your intellectual property rights are infringed on EasyEDA, please notify us by submitting relevant materials in accordance with the Rules for Complaints and Appeals of IPR Infringement.
Users must independently verify the circuit design and suitability when replicating this project. All risks and consequences are borne by the user, and the platform assumes no liability.
Empty
Comment