RPI CM4 NAS SATA PCIE

Raspberry Pi CM4 NAS Raspberry Pi Compute Module 4 Network Attached Storage PCB

I can not finish this project by now. Routing differential pairs is not very good in Easyeda. And adjusting length is almost impossible. I Hope someone else can do it. I would very much appreciate it. Also not that ther is a similar activity in Github (https://github.com/mebs/CM4-NAS)

I used RPI CM4 IO board datascheet as a startup. In order to make power distribution i used resettable fuses  (in IO board it is made of seversal different IC`s with SMD resistors). 

Routing should not be very hard as boad has wide area for each line. 

Routes are also quite simple and have small amount of intersections.

As for HDMI.

So, if you are experienced person and have ability to route differential lines please continue.