CompletedINTY PintyCard ProgInt
STDINTY PintyCard ProgInt
License
：CERN-OHL-W-2.0
Description
PintyCARD programming interface
This interface allows to program and debug the PintyCard (see https://oshwlab.com/yannick.erb/intv-pirto-hb )
A 3D Printable holding device is available from here : https://www.tinkercad.com/things/i1QFGbZg2C8-pintycard-programmer
It requires you to solder pogo pins that are 5mm high.
Once connected to the PintyCard, you'll have access to USB port and Debug ports.
U2,U3 and U4 are through hole components and can be hand soldered.
U2 offers access to the debug pins, simple inline connector os good.
For U3 and U4 5mm height pogo pin DIP connector with a 2.54mm pitch shall be used.
1x4 pins
and 2x3 pins:
Design Drawing
The preview image was not generated, please save it again in the editor.BOM
Bom empty
CloneProject Members
Intellectual Property Statement & Reproduction Instructions
This is an open-source hardware project. All intellectual property rights belong to the creator. The project is shared on the platform for learning, communication, and research only; any commercial use is prohibited. If your intellectual property rights are infringed on EasyEDA, please notify us by submitting relevant materials in accordance with the Rules for Complaints and Appeals of IPR Infringement.
Users must independently verify the circuit design and suitability when replicating this project. All risks and consequences are borne by the user, and the platform assumes no liability.
Empty
Comment